ANDEK
SOMAY/Andek "Polaroof RAC", (Color: "Aluminum") A single component, moisture-cured urethane, solvent-borne, elastomeric waterproofing sealant and coating for flat roof surfaces constructed of any normally used roofing material. "Polaroof RAC" is very tough and elastic with high tensile strength and good puncture resistance. The product contains fire retardant additives and corrosion-inhibiting aluminum flakes for additional protection against rust and acid rain. "Polaroof RAC" is approved by Underwriters Laboratories® (UL) and Factory Mutual Research corporation® (FM). It is ideal as a barrier coat or prime coat over old asphalt surfaces to prevent tar color "bleed through" and discoloration of the "White" color of any finish coating. Apply two (2) coats, each at a spreading rate of no more than 88 sq.ft./gal. per coat, to develop 15 mils DFT per coat, totaling 30 mils DFT for 2 coats. After roof application, be sure to keep the roof clean so dirt does not build up in low spots!
SOMAY/Andek "RUBBERKOTE" 1047 (Color: Light Gray), a single component, acrylic polymeric, solvent-borne coating especially engineered as a waterproofing coating for flat roof surfaces which have ponding water following a rainstorm where the use of other coatings will not perform satisfactorily. Can be applied to damp and wet roof surfaces where curing will occur even underwater, regardless of the thickness applied. "Rubberkote" 1047 adheres to all common roofing materials, whether horizontal or vertical. It is ideal for either instant repairs or as a permanent roof coating. Apply two (2) coats, each at 60 sq.ft./gal. to develop 15 mils DFT per coat, 30 mils DFT for both coats. Clean Up: Mineral Spirits. Dry Time: 60 Hours.
SOMAY/Andek ROOF FAB is also available for use in the situations listed above. It is a polyester-based, reinforcing fabric that can be embedded into any liquid-applied coating to boost cured membrane strength. It possesses a parallel fiber structure that is stitch bonded, which results in exceptional tensile, tear and elongation properties. ROOF FAB is naturally soft and conforms easily to irregular substrates. It is available in 324' rolls and in pre-cut 4" and 8" widths for ease of use. Click here for additional information on the use of ROOF FAB.
